THEFT DETERRENT SYSTEM (for Hatchback) > Security Horn Circuit |

| 1.PERFORM ACTIVE TEST USING TECHSTREAM (SECURITY HORN) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Active Test.
according to the display on the Techstream, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Security Horn | Security horn | OFF / ON | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT SECURITY HORN ASSEMBLY |
Inspect the security horn assembly (Click here).
|
| ||||
| OK | |
| 3.INSPECT EU-DRL/S-HORN RELAY |
![]() |
Remove the EU-DRL/S-HORN relay from No. 2 engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Battery voltage is not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage is applied to terminals 1 and 2 | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (EU-DRL/S-HORN RELAY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND SECURITY HORN) |
Disconnect the 3C instrument panel junction block assembly connector.
Disconnect the A49 security horn assembly connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Relay terminal 2 - 3C-20 | Always | Below 1 Ω |
| Relay terminal 3 - A49-1 | Always | Below 1 Ω |
| A49-2 - Body ground | Always | Below 1 Ω |
| 3C-20 - Body ground | Always | 10 kΩ or higher |
| A49-1 - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| Relay terminal 1 - Body ground | Always | 11 to 14 V |
| Relay terminal 5 - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 5.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
![]() |
Remove the instrument panel junction block assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3C-20 - MB-17 (SHRN) | Always | Below 1 Ω |
| *a | Component without harness connected (Instrument Panel Junction Block Assembly) |
|
| ||||
| OK | ||
| ||