Home › Drivetrain ยท AXLE AND DIFFERENTIAL › FRONT AXLE HUB BOLT (for Hatchback)

FRONT AXLE HUB BOLT (for Hatchback) > REPLACEMENT

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side as for the LH side.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT WHEELS


2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY


    C085618
  1. Remove the 2 bolts and separate the front disc brake caliper assembly.

    NOTICE:
    Hang the front disc brake caliper assembly using a piece of string or the equivalent.



3. REMOVE FRONT DISC


    C108932E02
  1. Place matchmarks on the disc and axle hub and remove the disc.
    Text in Illustration 
    *a
    Matchmark



4. REMOVE FRONT AXLE HUB BOLT


    C235848E01
  1. Using SST and a screwdriver or the equivalent to hold the axle hub, remove the hub bolt.
    Text in Illustration 
    *a
    Hold
    *b
    Turn

    SST
    09628-10011  



5. INSTALL FRONT AXLE HUB BOLT


    C235849E01
  1. Install the washer and the nut onto a new axle hub bolt, as shown in the illustration.
    Text in Illustration 
    *1
    Washer
    *2
    Nut
    *a
    Hold
    *b
    Turn

    Recommended Service Nut:
    Thread Diameter
    Thread Pitch
    12.0 mm (0.472 in.)
    1.5 mm (0.0591 in.)

    HINT:
    Recommended thickness of the washer is 5 mm (0.197 in.) or more.

  1. Using a screwdriver or the equivalent to hold the axle hub, install the axle hub bolt by tightening the nut.



6. INSTALL FRONT DISC


C108932E02
  1. Align the matchmarks of the disc and axle hub and install the disc.
    Text in Illustration 
    *a
    Matchmark

    HINT:
    When replacing the disc, select the position that gives the minimum disc runout.



7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
  1. Install the disc brake caliper onto the steering knuckle.

    Torque:
    107 N*m{ 1089 kgf*cm , 79 ft.*lbf }



8. INSTALL FRONT WHEELS

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }