DIFFERENTIAL CASE (for Hatchback) > INSPECTION |
| 1. INSPECT DIFFERENTIAL SIDE GEAR BACKLASH |
![]() |
Measure the front differential side gear backlash while holding 1 pinion gear toward the case.
Referring to the table below, select front differential side gear thrust washers which will ensure that the backlash is within the specifications for both sides.
| Part No. | Thickness mm (in.) |
| 41361-17010 | 0.95 (0.0374) |
| 41361-17020 | 1.00 (0.0394) |
| 41361-17030 | 1.05 (0.0413) |
| 41361-17040 | 1.10 (0.0433) |
| 41361-17050 | 1.15 (0.0453) |
| 41361-17060 | 1.20 (0.0472) |