CAN COMMUNICATION SYSTEM (for Hatchback) > Power Steering ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Power Steering ECU Communication Stop Mode | Either condition is met:
|
|

| 1.CHECK FOR OPEN IN CAN BUS WIRE (POWER STEERING ECU ASSEMBLY BRANCH WIRE) |
![]() |
Disconnect the D104 power steering ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D104-7 (CANH) - D104-8 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Rear view of wire harness connector (to Power Steering ECU Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
![]() |
Disconnect the A68 power steering ECU assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A68-1 (PIG) - Body ground | Always | 11 to 14 V |
| D104-1 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A68-2 (PGND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||