Home › Engine / Hybrid System › 1NZ-FE COOLING › COOLING FAN RESISTOR (for Hatchback)

COOLING FAN RESISTOR (for Hatchback) > ON-VEHICLE INSPECTION



1. INSPECT COOLING FAN RESISTOR


    A198875E03
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *a
      Component without harness connected
      (Cooling Fan Resistor)

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      1.17 to 1.43 Ω

      If the result is not as specified, replace the cooling fan resistor.