Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE HOOD COURTESY SWITCH (for Hatchback)

ENGINE HOOD COURTESY SWITCH (for Hatchback) > INSTALLATION



1. INSTALL ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)


    B284544
  1. Apply MP grease to the sliding areas of the engine hood courtesy switch (hood lock assembly).

  1. Connect the connector.

  1. Connect the hood lock control cable.

  1. Install the engine hood courtesy switch (hood lock assembly) with the 3 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



2. ADJUST HOOD SUB-ASSEMBLY


    B271586
  1. Loosen the 4 hood side hinge bolts.

  1. Move the hood to adjust the clearance to within the standard range (Click here).

  1. Tighten the 4 hood side hinge bolts after the adjustment.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



    B284563
  1. Adjust the height of the hood front end by turning the 2 center hood cushions (Click here).

    HINT:
    The center hood cushion can be raised and lowered by turning it.



  1. Adjust the hood lock.



      B273453
    1. Loosen the 3 bolts.

    2. Adjust the hood lock position so that the striker can enter it smoothly (Click here).

    3. Tighten the 3 bolts after the adjustment.

      Torque:
      7.5 N*m{ 76 kgf*cm , 66 in.*lbf }