AIR INLET CONTROL SERVO MOTOR (for Hatchback) > REMOVAL |
| 1. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY |
![]() |
Disengage the claw and separate the glove compartment door stopper from the glove compartment door.
Slightly flex the upper part of the glove compartment door to release the 2 stoppers and open the glove compartment door until it is horizontal.
![]() |
Pull the glove compartment door out horizontally to disengage the 2 hinges and 3 guides and remove the glove compartment door.
| *a | Hinge |
| *b | Guide |
| 2. REMOVE NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY |
![]() |
Disconnect the connector.
Remove the 2 screws and remove the blower damper servo.