Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT PILLAR UPPER COVER (for Hatchback)

FRONT PILLAR UPPER COVER (for Hatchback) > REMOVAL


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE FRONT PILLAR UPPER COVER SUB-ASSEMBLY


    B289843E02
  1. Apply protective tape to the vehicle body in the area around the front pillar upper cover.
    Text in Illustration 
    *1
    Protective Tape



    B289844E02
  1. Using a moulding remover, disengage the claw and 2 clips and remove the front pillar upper cover.
    Text in Illustration 
    *1
    Moulding Remover