CONDENSER (for Hatchback) > REMOVAL |
| 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM |
Start up the engine.
A/C switch on.
Turn the blower switch to on.
Operate the cooler compressor with an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the remaining compressor oil from each component, in the cooler compressor.
Stop the engine.
![]() |
Remove the caps from the service valves on the refrigerant line.
| *1 | High Pressure Service Valve |
| *2 | Low Pressure Service Valve |
Connect the refrigerant recovery unit.
Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.
| 2. REMOVE HEADLIGHT ASSEMBLY LH |
| 3. REMOVE HEADLIGHT ASSEMBLY RH |
| 4. REMOVE RADIATOR UPPER SUPPORT SUB-ASSEMBLY |
![]() |
Remove the 2 clips.
![]() |
Disconnect the connector.
![]() |
Disengage the 2 clamps and disconnect the hood lock control cable.
![]() |
Remove the 4 bolts and the radiator support.
| 5. REMOVE NO. 1 COOLER COVER |
![]() |
Disengage the 2 guides and remove the cooler cover.
| 6. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
![]() |
Remove the bolt and disconnect the cooler refrigerant discharge hose from the cooler condenser
Remove the O-ring from the cooler refrigerant discharge hose.
| 7. DISCONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY |
![]() |
Remove the bolt and disconnect the air conditioner tube and accessory from the cooler condenser.
Remove the O-ring from the air conditioner tube and accessory.
| 8. REMOVE COOLER CONDENSER ASSEMBLY |
![]() |
Disengage the 2 claws.
Disengage the 2 guides and remove the cooler condenser.