Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE (for Hatchback)

CAMSHAFT OIL CONTROL VALVE (for Hatchback) > INSTALLATION



1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
  1. Apply a light coat of engine oil to a new O-ring and install it onto the camshaft timing oil control valve assembly.

    NOTICE:
    Do not twist the O-ring.

  1. Install the camshaft timing oil control valve assembly with the bolt.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

    NOTICE:
    1. If a component has been dropped or subjected to a strong impact, replace it.
    2. Make sure that the O-ring is not damaged or does not jump out of position during installation.

  1. Connect the camshaft timing oil control valve assembly connector.



2. INSTALL NO. 2 CYLINDER HEAD COVER
  1. Install the No. 2 cylinder head cover with the 4 nuts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }