Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE (for Hatchback)

CAMSHAFT OIL CONTROL VALVE (for Hatchback) > INSPECTION




1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY


    A193057E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    6.9 to 7.9 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Camshaft Timing Oil Control Valve Assembly)
    If the result is not as specified, replace the oil control valve assembly.



    A248873E01
  1. Check the operation

    1. Connect the positive (+) lead from a battery to terminal 1 and the negative (-) lead to terminal 2, and check the movement of the valve.

      NOTICE:
      Confirm that the valve moves freely and does not stick in any position.

      If necessary, replace the camshaft timing oil control valve assembly.

      HINT:
      Accumulation of foreign matter can cause minor pressure leaks. Minor pressure leaks will cause the camshaft to advance or retard, and this will cause a DTC to be stored.

      Text in Illustration 
      *a
      Component without harness connected
      (Camshaft Timing Oil Control Valve Assembly)
      *b
      When applied
      *c
      When cut off