Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › ACCELERATOR PEDAL (for Hatchback)

ACCELERATOR PEDAL (for Hatchback) > INSTALLATION



1. INSTALL ACCELERATOR PEDAL ASSEMBLY

NOTICE:
  1. This accelerator pedal assembly does not require lubrication. Do not apply oil or other lubrication to the accelerator pedal assembly. If applied, the accelerator pedal assembly must be replaced.
  2. Do not disassemble the accelerator pedal.
  3. If a component has been dropped or subjected to a strong impact, replace it.

  1. Install the accelerator pedal assembly with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the accelerator pedal assembly connector.