Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › ACCELERATOR PEDAL (for Hatchback)

ACCELERATOR PEDAL (for Hatchback) > ON-VEHICLE INSPECTION



1. INSPECT ACCELERATOR PEDAL ASSEMBLY
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.

  1. Read the values displayed on the Techstream.

    Standard Voltage:
    Tester Display
    Condition
    Specified Condition
    Accel Sensor Out No. 1
    Accelerator pedal is released
    0.5 to 1.1 V
    Accelerator pedal is fully depressed
    2.6 to 4.5 V
    Accel Sensor Out No.2
    Accelerator pedal is released
    1.2 to 2.0 V
    Accelerator pedal is fully depressed
    3.4 to 4.7 V

    If the result is not as specified, check the accelerator pedal assembly, wire harness or ECM.