Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › MASS AIR FLOW METER (for Hatchback)

MASS AIR FLOW METER (for Hatchback) > INSTALLATION



1. INSTALL MASS AIR FLOW METER
  1. Install a new O-ring to the mass air flow meter.

    NOTICE:
    Do not twist the O-ring.

  1. Install the mass air flow meter with the 2 screws.

    Torque:
    1.0 N*m{ 10 kgf*cm , 9 in.*lbf }

    NOTICE:
    1. If a component has been dropped or subjected to a strong impact, replace it.
    2. Make sure that the O-ring is not damaged or does not jump out of position during installation.

    HINT:
    Perform "Inspection After Repairs" after replacing the mass air flow meter (Click here).

  1. Connect the mass air flow meter connector.

  1. Engage the wire harness clamp.