MASS AIR FLOW METER (for Hatchback) > ON-VEHICLE INSPECTION |
| 1. INSPECT MASS AIR FLOW METER |
Read the value using the Techstream (MAF).
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (do not run the engine).
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List / MAF.
Wait 30 for seconds, and read the values on the Techstream.
| Tester Display | Condition | Standard Condition |
| MAF |
| 0.20 gm/sec or less |