Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › CAMSHAFT POSITION SENSOR (for Hatchback)

CAMSHAFT POSITION SENSOR (for Hatchback) > INSTALLATION



1. INSTALL CAMSHAFT POSITION SENSOR


    A095434E20
  1. Apply a light coat of engine oil to the O-ring.
    Text in Illustration 
    *1
    O-ring

    NOTICE:
    If reusing the camshaft position sensor, be sure to inspect the O-ring.

  1. Install the camshaft position sensor with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    NOTICE:
    1. If a component has been dropped or subjected to a strong impact, replace it.
    2. Make sure that the O-ring is not damaged or does not jump out of position during installation.

  1. Connect the camshaft position sensor connector.



2. INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE
  1. Install the air cleaner cap sub-assembly with No. 1 air cleaner hose onto the throttle body assembly

  1. Engage the 2 clamps and connect the air cleaner cap sub-assembly to the air cleaner case sub-assembly.

  1. Tighten the hose clamp.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }

  1. Connect the vacuum switching valve assembly connector.

  1. Connect the mass air flow meter connector.

  1. Engage the 2 clamps and connect the wire harness to the air cleaner cap sub-assembly and vacuum switching valve assembly.

  1. Connect the No. 2 fuel vapor feed hose to the intake manifold.

  1. Connect the fuel vapor feed hose assembly to the No. 1 air cleaner hose and vacuum switching valve assembly with the 2 hose clamps.

  1. Engage the clamp and connect the fuel vapor feed hose assembly to the No. 1 air cleaner hose.



3. INSTALL BATTERY
  1. Install the battery.

  1. Install the battery clamp with the 2 nuts.

    Torque:
    3.5 N*m{ 36 kgf*cm , 31 in.*lbf }



4. INSTALL NO. 2 CYLINDER HEAD COVER
  1. Install the No. 2 cylinder head cover with the 4 nuts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



5. INSPECT FOR ENGINE OIL LEAK