Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR (for Hatchback)

ENGINE COOLANT TEMPERATURE SENSOR (for Hatchback) > INSPECTION



1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR


    A093604E23
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *1
    Ohmmeter
    *a
    Component without harness connected
    (Engine Coolant Temperature Sensor)

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    2.32 to 2.59 kΩ
    80°C (176°F)
    0.310 to 0.326 kΩ

    NOTICE:
    In case of checking the engine coolant temperature sensor in water, do not allow water to contact the terminals. After checking, dry the engine coolant temperature sensor.

    If the result is not as specified, replace the engine coolant temperature sensor.