Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › KNOCK SENSOR (for Hatchback)

KNOCK SENSOR (for Hatchback) > INSTALLATION



1. INSTALL KNOCK SENSOR


    A172936E07
  1. Install the knock sensor onto the cylinder block with the nut as shown in the illustration.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

    NOTICE:
    1. Make sure that the knock sensor is in the correct position.
    2. If a component has been dropped or subjected to a strong impact, replace it.

    HINT:
    Perform "Inspection After Repairs" after replacing the knock sensor (Click here).

  1. Connect the knock sensor connector.



2. INSTALL INTAKE MANIFOLD
(Click here)