Home › Vehicle Interior › HEATING / AIR CONDITIONING › RELAY (for Hatchback)

RELAY (for Hatchback) > ON-VEHICLE INSPECTION



1. INSPECT HEATER BLOWER MOTOR RELAY ASSEMBLY


    E223161
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 4
      Battery voltage not applied
      Below 1 Ω
      3 - 4
      Battery voltage applied to terminals 1 and 2
      10 kΩ or higher
      3 - 5
      Battery voltage not applied
      10 kΩ or higher
      3 - 5
      Battery voltage applied to terminals 1 and 2
      Below 1 Ω

      1. If the result is not as specified, replace the heater blower motor relay.