CRUISE CONTROL SYSTEM (for Hatchback) > DATA LIST / ACTIVE TEST |
| DATA LIST |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Cruise Control / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| CCS Vehicle Spd | Vehicle speed / Min.: 0 km/h (0 mph), Max.: 255 km/h (159 mph) | Actual vehicle speed displayed | - |
| CCS Mem Vehicle Spd | Vehicle speed / Min.: 0 km/h (0 mph), Max.: 255 km/h (159 mph) | Vehicle speed stored in memory | - |
| Throttle Opening Angle | Required throttle opening amount / Min.: 0°, Max.: 124.5° | Required throttle opening angle | - |
| Cruise Control | Cruise control / OFF or ON | OFF: Cruise control not set ON: Cruise control set | - |
| Main SW M-CPU | Cruise control main switch (Main CPU) / OFF or ON | OFF: Cruise control main switch off ON: Cruise control main switch on | - |
| CCS Ready M-CPU | Cruise control system standby condition (Main CPU) / OFF or ON | OFF: Cruise control main switch off ON: Cruise control main switch on | - |
| CCS Indicator M-CPU | Cruise control indicator (Main CPU) / OFF or ON | OFF: Cruise control indicator light off ON: Cruise control indicator light on | - |
| Cancel Switch | CANCEL switch signal / OFF or ON | OFF: CANCEL switch off ON: CANCEL switch on | - |
| SET/COAST Switch | -SET switch signal / OFF or ON | OFF: -SET switch off ON: -SET switch on | - |
| RES/ACC Switch | +RES switch signal / OFF or ON | OFF: +RES switch off ON: +RES switch on | - |
| Stp Light SW M-CPU | Stop light switch signal (Main CPU) / OFF or ON | OFF: Brake pedal released ON: Brake pedal depressed | - |
| Cruise Operation Status | Shift lever position signal / OFF or ON | OFF: Shift lever not in D ON: Shift lever in D | - |
| Brake Cancel Switch | Brake cancel signal / OFF or ON | OFF: Brake pedal released ON: Brake pedal depressed | - |
| ACTIVE TEST |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
According to the display on the Techstream, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. Lamp Cruise | Cruise control indicator light | OFF/ON | Vehicle is stopped and engine is idling |
| Indicat. SET | Cruise control SET indicator light | OFF/ON | Vehicle is stopped and engine is idling |