Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH (for Hatchback)

STOP LIGHT SWITCH (for Hatchback) > INSTALLATION



1. INSTALL STOP LIGHT SWITCH ASSEMBLY


    E167768
  1. Insert the stop light switch assembly until the rod hits the pedal.

    HINT:
    When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.



    E167769
  1. Make a quarter turn clockwise to install the stop light switch assembly.

    HINT:
    When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf } or less

  1. Check the protrusion of the rod.

    Protrusion of the rod:
    0.5 to 2.6 mm (0.020 to 0.102 in.)

  1. Connect the connector.



2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Engage the guide and the claw.

  1. Install the instrument panel under cover with the 2 <A> screws.