COOLER EXPANSION VALVE (for Hatchback) > REMOVAL |
| 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM |
Start up the engine.
A/C switch on.
Turn the blower switch to on.
Operate the cooler compressor with an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the remaining compressor oil from each component, in the cooler compressor.
Stop the engine.
![]() |
Remove the caps from the service valves on the refrigerant line.
| *1 | High Pressure Service Valve |
| *2 | Low Pressure Service Valve |
Connect the refrigerant recovery unit.
Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.
| 2. DISCONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY |
![]() |
Remove the bolt.
Turn the hook connector clockwise and disconnect the air conditioner tube and liquid tube.
Remove the O-ring from the air conditioner tube and liquid tube.
| 3. REMOVE COOLER EXPANSION VALVE |
![]() |
Using a 4 mm hexagon wrench, remove the 2 hexagon bolts.
![]() |
Temporarily attach the bolt for the air conditioner tube and accessory assembly halfway to the cooler expansion valve.
| *1 | Bolt For The Air Conditioner Tube and Accessory Assembly |
![]() |
Hold the bolt and pull it to remove the cooler expansion valve as shown in the illustration.
![]() |
Remove the 2 O-rings from the cooler evaporator.
| *1 | Cooler Evaporator |