Home › Vehicle Exterior › WIPER / WASHER › WASHER LEVEL WARNING SWITCH (for Hatchback)

WASHER LEVEL WARNING SWITCH (for Hatchback) > INSTALLATION



1. INSTALL LEVEL WARNING SWITCH ASSEMBLY
  1. Install the washer jar protector to the washer jar.



    E229490E01
  1. Install the level warning switch onto the packing of the washer jar assembly.
    Text in Illustration 
    *a
    Dimension A
    *b
    Projection

    HINT:
    When level warning switch is assembled, projection should be set up within dimension A.

  1. Connect the connector.



2. ADD WINDSHIELD WASHER FLUID
  1. Add washer fluid to the washer jar.



3. INSTALL FRONT FENDER LINER RH

HINT:
Use the same procedure as for the LH side .



4. INSTALL FRONT WHEEL RH

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }