WASHER LEVEL WARNING SWITCH (for Hatchback) > INSPECTION |
| 1. INSPECT LEVEL WARNING SWITCH ASSEMBLY |
Fill the washer jar with washer fluid.
![]() |
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Level Warning Switch Assembly) |
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Fluid volume is more than 600 to 800 ml | 10 kΩ or higher |
| 1 - 2 | Fluid volume is less than 600 to 800 ml | Below 1 Ω |