Home › Vehicle Exterior › WIPER / WASHER › WASHER LEVEL WARNING SWITCH (for Hatchback)

WASHER LEVEL WARNING SWITCH (for Hatchback) > REMOVAL



1. REMOVE FRONT WHEEL RH


2. REMOVE FRONT FENDER LINER RH

HINT:
Use the same procedures for the LH side .



3. DRAIN WINDSHIELD WASHER FLUID


    E221602
  1. Disconnect the washer hose from the windshield washer motor and pump, and drain the washer fluid.

    CAUTION:
    Use a container to collect the washer fluid.



4. REMOVE LEVEL WARNING SWITCH ASSEMBLY


    E229488
  1. Disconnect the connector.



    E229489
  1. Pull the level warning switch out of the packing of the washer jar assembly.

  1. Remove the washer jar protector from the washer jar.