STEERING SYSTEM (for Sedan) > ADJUSTMENT |
| 1. ADJUST STEERING WHEEL OFF CENTER |
![]() |
Check whether the steering wheel is off-center.
Apply masking tape to the top center of the steering wheel and the steering column upper cover.
Drive the vehicle in a straight line for 100 meters at a constant speed of 35 mph (56 km/h), holding the steering wheel to maintain the course.
![]() |
Draw a line on the masking tape, as shown in the illustration.
![]() |
Turn the steering wheel to the straight position.
Draw another line on the masking tape on the steering wheel, as shown in the illustration.
Measure the distance between the 2 lines on the masking tape on the steering wheel.
Convert the measured distance to the steering angle.
Adjust the steering angle
![]() |
For steps (1) and (2) below, carry out RH and LH procedures separately.
Draw a line on the tie rod and rack end where it can easily be seen.
Using a paper gauge, measure the distance between the tie rod end and the rack end screw.
![]() |
Remove the RH and LH boot clips from the rack boots.
Loosen the RH and LH lock nuts.
Turn the RH and LH rack ends by the same amount (but in opposite directions) in accordance with the steering angle.
Tighten the RH and LH lock nuts.
Install the RH and LH boot clips.