Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › SIDE MUDGUARD (for Hatchback)

SIDE MUDGUARD (for Hatchback) > REMOVAL


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE ROCKER PANEL MOULDING COVER


    B273190E01
  1. Using a moulding remover, disengage the 2 claws and remove the rocker panel moulding cover.
    Text in Illustration 
    *1
    Moulding Remover



2. REMOVE SIDE MUDGUARD SUB-ASSEMBLY


    B273192
  1. Remove the screw.

  1. Remove the 8 retainers.



    B273193
  1. Disengage the 7 clips and remove the side mudguard.



3. REMOVE SIDE MUDGUARD REAR PROTECTOR


    B273337
  1. While peeling off the double-sided adhesive tape, and remove the side mudguard rear protector.



4. REMOVE SIDE MUDGUARD PROTECTOR


    B273194
  1. While peeling off the double-sided adhesive tape, remove the side mudguard protector.