Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RESET SWITCH (for Hatchback)

TIRE PRESSURE WARNING RESET SWITCH (for Hatchback) > REMOVAL



1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    C244974
  1. Remove the 2 screws.

  1. Disengage the claw and the guide and remove the No. 1 instrument panel under cover sub-assembly.



2. REMOVE TIRE PRESSURE WARNING RESET SWITCH
  1. Disconnect the tire pressure warning reset switch connector.



    C244975
  1. Disengage the 2 claws to remove the tire pressure warning reset switch from the No. 1 instrument panel under cover sub-assembly.