Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.
Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.
Wipe off the remaining double-sided tape using a clean cloth or equivalent.
If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.
After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.
The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.
| *A | for 1NZ-FE | - | - |
| *1 | LUGGAGE COMPARTMENT DOOR EMBLEM | *2 | NO. 1 LUGGAGE COMPARTMENT DOOR NAME PLATE |
| *3 | NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE | *4 | NO. 3 LUGGAGE COMPARTMENT DOOR PLATE |
| *5 | NO. 4 LUGGAGE COMPARTMENT DOOR PLATE | - | - |
| ● | Non-reusable part | - | - |
NO. 4 LUGGAGE COMPARTMENT DOOR PLATE
for 1NZ-FE:
| *1 | Luggage Compartment Door | - | - |
| Mark | Measurement (along surface) | Mark | Measurement (along surface) |
| A | 58.3 mm (2.30 in.) | B | 100.4 mm (3.95 in.) |
| C | 58.6 mm (2.31 in.) | D | 121.8 mm (4.80 in.) |
for 2NZ-FE:
| *1 | Luggage Compartment Door | - | - |
| Mark | Measurement (along surface) | Mark | Measurement (along surface) |
| A | 73.7 mm (2.90 in.) | B | 103.7 mm (4.08 in.) |
| C | 74.0 mm (2.91 in.) | D | 126.4 mm (4.98 in.) |
NO. 3 LUGGAGE COMPARTMENT DOOR PLATE (for 1NZ-FE)
| *1 | Luggage Compartment Door | - | - |
| Mark | Measurement (along surface) | Mark | Measurement (along surface) |
| A | 66.0 mm (2.598 in.) | B | 110.1 mm (4.33 in.) |
| C | 114.4 mm (4.504 in.) | D | 122.7 mm (4.83 in.) |
NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE
| *1 | Luggage Compartment Door | - | - |
| Mark | Measurement (along surface) | Mark | Measurement (along surface) |
| A | 7.9 mm (0.311 in.) | B | 4.1 mm (0.161 in.) |
| C | 145.3 mm (5.72 in.) | D | 26.1 mm (1.03 in.) |
NO. 1 LUGGAGE COMPARTMENT DOOR NAME PLATE
| *1 | Luggage Compartment Door | - | - |
| Mark | Measurement (along surface) | Mark | Measurement (along surface) |
| A | 4.7 mm (0.185 in.) | B | 16.8 mm (0.661 in.) |
| C | 121.1 mm (4.77 in.) | D | 4.0 mm (0.157 in.) |
LUGGAGE COMPARTMENT DOOR EMBLEM
| *a | Location Pin |