Refer to the TOYOTA Repair Manual for each work procedure.
PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED
| Replacement Part | Necessary Procedure | Effect/Inoperative Function when Necessary Procedures are not Performed | Note |
|---|---|---|---|
·
Throttle body with motor assembly ·
ECM |
Learning values write | ·
Engine starting ·
Idling |
- |
·
Automatic transaxle assembly ·
Engine assembly ·
ECM |
·
Road test ·
Reset memory |
Large shift shock | - |
·
Power steering motor assembly ·
Power steering ECU assembly ·
Electric power steering column sub-assembly (containing the torque sensor) |
Torque sensor zero point calibration | ·
EPS warning light comes on ·
EPS control |
- |
| ECM | ECU communication ID registration (Immobiliser system) | Engine start | Refer to the Service Bulletin for the registration method. |
·
Transponder key ECU assembly*1 ·
Key*1 |
Code registration (Immobiliser system) | Engine start | |
·
Certification ECU (smart key ECU assembly)*2 ·
Steering lock ECU (steering lock actuator assembly)*2 ·
Electrical key transmitter sub-assembly*2 |
Code registration (Immobiliser system) | ·
Wireless door lock control system ·
Smart Entry and Smart System ·
Engine start ·
Steering lock system |
|
·
Door control transmitter assembly*1 ·
Door control receiver*1 |
Code registration (Wireless door lock system) | Wireless door lock control system | - |
·
Front door window regulator assembly LH ·
Front power window regulator motor assembly LH ·
Door glass ·
Door glass run |
Initialize power window control system | ·
Auto up and down function ·
Jam protection function |
- |
*1: w/o Smart Entry and Start System
*2: w/ Smart Entry and Start System