Point O, o on the vehicle are asymmetrical.
In cases in which only one dimension is given, left and right are symmetrical.
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter
mm (in.) |
|---|---|---|
| A, a | Front Fender Installation Nut | M6 (0.24) |
| B, b | Front Spring Support Standard Hole | φ11 (0.43) |
| C, c | Hood Hinge Installation Nut | M8 (0.31) |
| D | Cowl Top Panel Center Mark | 7X6.2
(0.28X0.24) |
| E, e | Front Side Member Standard Hole | φ15 (0.59) |
| F, f | Front Side Member Standard Hole | φ10 (0.39) |
| G, g | Radiator Upper Support Installation Nut | M6 (0.24) |
| H, h | Front Bumper Reinforcement Installation Bolt | M10 (0.39) |
| J, j | Radiator Support Standard Hole | φ10 (0.39) |
| K | Hood Lock Brace Installation Nut | M6 (0.24) |
| L, l | Front Fender Mounting Bracket Standard Hole | φ10 (0.39) |
| M, m | Radiator Upper Support Installation Nut | M6 (0.24) |
| N, n | Radiator Side Support Installation Nut | M6 (0.24) |
| O, o | Front Side Member Plate No. 2 Standard Hole | φ10 (0.39) |
| P, p | Headlight Installation Nut | M6 (0.24) |
| Q, q | Radiator Side Support Installation Nut | M6 (0.24) |
| *a | Distance between points other than those above | *b | Height from Imaginary Datum Line |
| *c | mm
(in.) |
- | - |