Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING OR REPLACING PARTS › 2014.03–2017.10
BM30M0E _V1 General _068870 INTRODUCTION _0336217 WHEN REMOVING,INSTALLING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING OR REPLACING PARTS  PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED  


Refer to the TOYOTA Repair Manual for each work procedure.

PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Replacement Part Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed Note
·

Throttle body with motor assembly

·

ECM


Learning values write
·

Engine start

·

Idling


-
·

Automatic transaxle assembly

·

Engine assembly

·

ECM


·

Road test

·

Reset memory


Large shift shock -
·

Power steering motor assembly

·

Power steering ECU assembly

·

Electric power steering column sub-assembly (containing the torque sensor)


Torque sensor zero point calibration
·

EPS warning light comes on

·

EPS control


-
ECM ECU communication ID registration (Immobiliser system) Engine start Refer to the Service Bulletin for the registration method.
·

Transponder key ECU assembly*1

·

Key*1


Code registration (Immobiliser system) Engine start
·

Certification ECU (smart key ECU assembly)*2

·

Steering lock ECU (steering lock actuator assembly)*2

·

Electrical key transmitter sub-assembly*2


Code registration (Immobiliser system)
·

Wireless door lock control system

·

Smart entry and start system

·

Engine start

·

Steering lock system


·

Door control transmitter assembly*1

·

Door control receiver*1


Code registration (Wireless door lock system) Wireless door lock control system -
·

Front door window regulator assembly LH*3, RH*4

·

Front power window regulator motor assembly LH*3, RH*4

·

Door glass

·

Door glass run


Initialize power window control system
·

Auto up and down function

·

Jam protection function


-

*1: w/o Smart Entry and Start System

*2: w/ Smart Entry and Start System

*3: for LHD

*4: for RHD