With the body lower back panel removed.
REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Remove Weld Points |
|
Cut and Join Location |
*a is reused.
After removing the *a, remove the rear floor side member sub-assembly.
| *1 | REAR FLOOR SIDE MEMBER SUB-ASSEMBLY | - | - |
| *a | Reused | *b | mm (in.) |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Plug Weld |
|
Plug Weld |
|
Butt Weld |
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
After welding the rear floor side member sub-assembly to the vehicle side, install the *a.
After welding, apply body sealer and undercoating to the corresponding parts. (See the painting/coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.
| *1 | REAR FLOOR SIDE MEMBER SUB-ASSEMBLY | - | - |