Refer to the TOYOTA Repair Manual for each work procedure.
PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED
| Replacement Part | Necessary Procedure | Effect/Inoperative Function when Necessary Procedures are not Performed | Note |
|---|---|---|---|
| ECM | Perform Vehicle Identification Number (VIN) registration | MIL comes on | - |
·
Throttle body with motor assembly ·
Cleaning the deposits from the throttle body with motor assembly ·
Engine assembly ·
Cylinder head sub-assembly ·
Camshaft (for intake or exhaust camshaft) ·
Camshaft timing gear assembly ·
Camshaft timing exhaust gear assembly ·
Piston or piston ring ·
Mass air flow meter ·
Fuel injector assembly ·
Fuel pump ·
Air fuel ratio sensor ·
Engine coolant temperature sensor ·
Spark plug ·
No. 1 ignition coil ·
Air leaks from intake system ·
Gas leaks from exhaust system ·
Knock sensor |
Inspection after repair | Poor idle, engine start, etc. | - |
·
Continuously variable transaxle assembly ·
ECM ·
Oil pressure sensor ·
Yaw rate and acceleration sensor (airbag ECU assembly) |
·
Reset memory ·
Deceleration sensor zero point calibration ·
CVT oil pressure calibration |
Deterioration of fuel efficiency | - |
| CVT fluid | Perform ATF thermal degradation estimate reset | The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly | |
| Skid control ECU (brake actuator assembly)*1 | Perform yaw rate and acceleration sensor zero point calibration and store system information | ·
VSC disabled or malfunctions ·
DTCs are stored ·
Slip indicator light illuminates ·
ABS warning light illuminates |
- |
| Yaw rate and acceleration sensor (airbag ECU assembly)*1 | ·
Clear zero point calibration data and store system information ·
Perform yaw rate and acceleration sensor zero point calibration and store system information |
||
·
Power steering motor assembly ·
Power steering ECU assembly ·
Electric power steering column sub-assembly (containing the torque sensor) |
Perform torque sensor zero point calibration | ·
DTCs are stored ·
EPS warning light illuminates |
- |
| ECM | ECU communication ID registration (Immobiliser system) | Engine start | See Service Bulletin for the registration method. |
·
Transponder key ECU assembly*2 ·
Key*2 |
Code registration (Immobiliser system) | Engine start | |
·
Certification ECU (smart key ECU assembly)*3 ·
Steering lock ECU (steering lock actuator assembly)*3 ·
Electrical key transmitter sub-assembly*3 |
Code registration (Immobiliser system) | ·
Wireless door lock control system ·
Smart entry and start system ·
Engine start ·
Steering lock system |
|
·
Door control transmitter assembly*2 ·
Door control receiver*2 |
Code registration (Wireless door lock control system) | Wireless door lock control system | - |
·
Front door window regulator assembly LH*4, RH*5 ·
Front power window regulator motor assembly LH*4, RH*5 ·
Door glass ·
Door glass run |
Initialize power window control system | ·
Auto up and down function ·
Jam protection function |
- |
| Body ECU*6 | Initialize automatic light control system | Automatic light control system | - |
*1: w/ VSC
*2: w/o Smart Entry and Start System
*3: w/ Smart Entry and Start System
*4: for LHD
*5: for RHD
*6: w/ Automatic Light Control System