FUNCTION OF MAIN COMPONENTS
The airbag system mainly consists of the parts listed in the table below.
| Component | Outline |
|---|---|
| Airbag | Mainly consists of an inflator and a bag. Upon receiving a deployment signal from the airbag ECU assembly, the inflator generates gas to deploy the bag. |
| Front Seat Outer Belt Assembly | Mainly consists of an inflator and a seat belt. Upon receiving a deployment signal from the airbag ECU assembly, the inflator generates gas to retract the seat belt. |
| Front Airbag Sensor | Detects the deceleration of the vehicle during a collision, and transmits the signal to the airbag ECU assembly, from which the airbag ECU assembly determines whether ignition is necessary. |
| Airbag ECU Assembly | ·
Detects the deceleration of the vehicle during a collision, determines whether ignition is necessary based on the signals from each airbag sensor, and transmits deployment signals to airbag and seat belt pretensioner. ·
Provides initial check and diagnosis function. ·
Sends the airbag deployment signal to the ECM through the Controller Area Network (CAN) to operate the fuel pump control. |
| ECM | Stops the fuel pump when both of the SRS airbags have deployed. |
| SRS Warning Light | Provided in the combination meter assembly and comes on when the airbag system malfunctions. |
OPERATING CONDITION
Ignition Condition
Deceleration sensors used for the airbag system are installed on various parts on the vehicle and transmit the deceleration data of each part during a collision.
Frontal collision signals are produced based on the information from the airbag ECU assembly and the front airbag sensor. Frontal collision signals are used to deploy the SRS driver airbag (horn button assembly), SRS front passenger airbag (instrument panel passenger airbag assembly) and to activate each seat belt pretensioner.
SYSTEM CONTROL
Airbag for Frontal Collision
For frontal collisions, there are 2 airbags and 2 seat belt pretensioners: a SRS driver airbag (horn button assembly), SRS front passenger airbag (instrument panel passenger airbag assembly), seat belt pretensioner LH and seat belt pretensioner RH . The deployment of the airbags and the activation of each seat belt pretensioner occur simultaneously.
Primary Check Illumination Control
After the ignition switch is turned ON, the airbag ECU assembly illuminates the SRS warning light in the combination meter assembly for approximately 6 seconds and conducts the primary check. During the primary check, the ignition of airbags is prohibited and a diagnosis of the airbag ECU assembly is performed. If trouble is detected during the primary check, the SRS warning light remains on even after the 6 seconds have elapsed. See the illustration below.
DIAGNOSIS
If the airbag ECU assembly detects a malfunction in the airbag system, the airbag ECU assembly stores the malfunction data in memory, in addition to illuminating the SRS warning light.
There are 2 types of Diagnostic Trouble Code (DTC) for the airbag system: 5-digit and 2-digit.
The 5-digit DTC can be read by connecting the Global TechStream (GTS) to DLC3.
The 2-digit DTC can be read by connecting the SST (09843-18040) to the TC and CG terminals of the DLC3 and reading the blinking of the SRS warning light.
If the SRS airbag deploys, the airbag ECU assembly will turn on the SRS warning light. However, different from the ordinary diagnosis function, a DTC will not be stored. The SRS warning light cannot be turned off. It is necessary to replace the airbag ECU assembly with a new one.