OUTLINE
A manual air conditioning system or automatic air conditioning system is used.
SPECIFICATION
Performance
| Item | Specification | ||
| Heater | Heater Output | W | 4400 |
| Air Flow Volume | m3/h | 280 | |
| Power Consumption | W | 190 | |
| Cooler | Cooling Capacity | W | 4500 |
| Air Flow Volume | m3/h | 450 | |
| Power Consumption | W | 220 | |
Ventilation and Heater Radiator Unit Sub-assembly
| Item | Specifications | ||
| Heater Radiator Unit Sub-assembly | Type | Straight Flow Aluminum (SFA)-II | |
| Size
W x H x L |
mm (in.) | 232.7x130x21 (9.2x5.1x0.8) | |
| Fin Pitch | mm (in.) | 1.8 (0.07) | |
| Blower with Fan Motor Sub-assembly | Motor Type | K62-10 | |
| Fan Type | Shroud Sirocco | ||
| Fan Size (Dia. x H) | mm (in.) | 110x74 (4.3x2.9) | |
Air Conditioning
| Cooler Condenser Assembly | Type | Multi-Flow (MF)-IV | |
| Size
W x H x L |
mm (in.) | 640x319x16 (25.2x12.5x0.6) | |
| Fin Pitch | mm (in.) | 3.15 (0.12) | |
| No. 1 Cooler Evaporator Sub-assembly | Type | Revolutionary super-slim Structure (RS) | |
| Size
W x H x L |
mm (in.) | 185.9x251x38 (7.3x9.9x1.5) | |
| Fin Pitch | mm (in.) | 2.6 (0.1) | |
| Cooler Compressor Assembly | Type | 10SE13C | |
| Pulley | Magnetic Clutch | ||
| Refrigerant | Type | HFC 134a | |
| Charge Volume | g | 400+/-50 | |
| Clean Air Filter | Semi Standard Type | ||
MAIN FEATURES
The air conditioning system has the following features:
|
*: Models with automatic air conditioning system |
|
| High Performance | ·
Neural network control is used so passengers can control the air conditioning accurately for maximum comfort.* ·
The blower control has 7 levels in manual mode and 31 levels in auto mode for more precise control.* |
| Lightweight | A bus connector (air conditioning harness assembly) with a built-in IC is used in a lightweight wire harness design with a reduced number of wires. The use of this connector means that pulse pattern type servo motors are used.* |
| Compact | ·
A semi-center location air conditioning unit in which the cooler evaporator sub-assembly and heater radiator unit sub-assembly are placed in the vehicle's longitudinal direction is used. ·
A blower motor with a built-in blower motor controller is used in a compact construction. |
| Others | The following parts are used to ensure high cooling performance while realizing a compact and lightweight construction.
·
Semi-center location air conditioning unit ·
Revolutionary super-slim Structure (RS) evaporator ·
Multi-Flow (MF)-IV sub-cool condenser assembly |