CONSTRUCTION
Pick-up coil type sensors are used for the crank position sensor and cam position sensor.
The timing sprocket of the crankshaft has 34 teeth, with 2 teeth missing. Based on these teeth, the crank position sensor transmits crank position signals (NE signal) consisting of 33 high or low output pulses every 10° per revolution of the crankshaft, and 1 high or low output pulse every 30°. The ECM uses the NE signal for detecting the crank position as well as for detecting the engine speed. It uses the missing teeth signal for determining the top dead center.
To detect the cam position, a timing rotor on the intake camshaft is used to generate 3 (3 high output, 3 low output) pulses for every 2 revolutions of the crankshaft.
| *1 | Crank Position Sensor | *2 | Timing Sprocket |
| *3 | Cam Position Sensor | *4 | Timing Rotor |