Home › Engine / Hybrid System › 2NZ-FE ENGINE CONTROL › SFI SYSTEM › 2013.08–2016.10
NM30M0E _51 Engine / Hybrid System _018293 2NZ-FE ENGINE CONTROL _0090361 SFI SYSTEM DE DETAILS F

2NZ-FE ENGINE CONTROL  SFI SYSTEM  DETAILS  FUEL PUMP CONTROL  


OPERATION


a.

Fuel Cut Control (Models with Airbag System)

i.

The fuel pump control is used to stop the fuel pump when the SRS airbags deploy in a frontal collision.


ii.

In this system, the airbag deployment signal from the airbag ECU assembly is detected by the ECM, which turns off the circuit opening relay (C/OPN relay).


iii.

After the fuel cut control has been activated, turning the ignition switch from off to ON cancels the fuel cut control, and the engine can be restarted.

W111017E01
0.208,1.146 1,1.594 0.792,0.448 10 false Front Airbag Sensor 2.042,1.146 2.813,1.656 0.771,0.51 10 false Airbag ECU Assembly 3.073,1.563 3.656,2.031 0.583,0.469 10 false CAN (V Bus) 4.052,1.25 4.563,1.698 0.51,0.448 10 false ECM 3.406,0.208 5.354,0.542 1.948,0.333 10 false IG2 Relay*1 / Ignition Switch*2 5.698,1.792 6.823,2.083 1.125,0.292 10 false Fuel Pump Motor 5.719,0.771 7.073,1.281 1.354,0.51 10 false Circuit Opening Relay (C/OPN Relay) 5.604,0.188 6.24,0.521 0.635,0.333 10 false EFI Relay 0.146,1.958 3.031,2.26 2.885,0.302 10 false *1: Models with Smart Entry and Start System 0.156,2.344 3.25,2.625 3.094,0.281 10 false *2: Models without Smart Entry and Start System