Home › Engine / Hybrid System › 1NZ-FE ENGINE MECHANICAL › ENGINE UNIT › 2013.08–2016.10
NM30M0E _51 Engine / Hybrid System _018285 1NZ-FE ENGINE MECHANICAL _0090362 ENGINE UNIT DE DETAILS F

1NZ-FE ENGINE MECHANICAL  ENGINE UNIT  DETAILS  VVT-i CONTROLLER  


CONSTRUCTION


a.

The VVT-i controller (camshaft timing gear assembly) consists of the housing driven from the chain sub-assembly and the vane coupled with the camshaft.


b.

The oil pressure sent from the advance or retard side path at the camshaft causes rotation in the VVT-i controller (camshaft timing gear assembly) vane circumferential direction to vary the intake valve timing continuously.


c.

When the engine is stopped, the camshaft will be in the most retarded state to ensure startability.


d.

When hydraulic pressure is not applied to the VVT-i controller (camshaft timing gear assembly) immediately after the engine has been started, the lock pin locks the movement of the VVT-i controller (camshaft timing gear assembly) to prevent a knocking noise.

W104607C02
2.844,0.573 2.979,0.573 2.979,0.573 3.417,0.948 true 3.948,0.99 4.333,0.448 4.333,0.448 4.438,0.448 true 4.99,0.927 5.24,0.531 5.24,0.531 5.344,0.531 true 4.021,1.281 4.635,1.823 4.635,1.823 4.76,1.823 true 2.792,2.521 3,2.729 0.208,0.208 10 false *a 3.313,3.208 3.521,3.417 0.208,0.208 10 false *b 4.188,3.208 4.396,3.417 0.208,0.208 10 false *c 2.667,0.51 2.875,0.719 0.208,0.208 10 false *1 4.5,0.375 4.708,0.583 0.208,0.208 10 false *2 5.406,0.427 5.615,0.635 0.208,0.208 10 false *3 4.813,1.75 5.021,1.958 0.208,0.208 10 false *4
*1 Housing *2 Lock Pin
*3 Camshaft (Intake) *4 Vane
*a Lock Pin Operation *b Engine Stopped
*c Engine Operating - -
V100135

Oil Pressure - -