FUNCTION OF MAIN COMPONENTS
The main components of the blowby gas ventilation system are as follows:
| Component | Function |
|---|---|
| Ventilation Valve Sub-assembly | Opens and closes the valve using vacuum generated in the intake manifold and controls the flow rate of the blowby gas. |
SYSTEM CONTROL
By introducing blowby gas that has a large amount of HC into the air intake side and burning it again, the system attempts to enhance the emission performance. Returning blowby gas volume is regulated to the appropriate amount corresponding to the engine operating conditions, reducing the engine oil quantity taken away and engine idling speeds.
The ventilation valve sub-assembly passage returns the blowby gas into the area after the throttle valve in accordance with the intake manifold vacuum.
When load is low, the passage from the cylinder head cover sub-assembly to the area before the throttle valve increases the air purification performance inside the crankcase by introducing fresh air, and when load is high, the passage circulates the blowby gas together with the ventilation valve sub-assembly side passage due to the intake manifold vacuum.
| *1 | Ventilation Valve Sub-assembly | - | - |
| *a | When load is low | *b | When load is high |
|
Blowby Gas |
|
Fresh Air |