Home › Engine / Hybrid System › 1NZ-FE EMISSION CONTROL › EMISSION CONTROL SYSTEM › 2013.08–2014.03
NM30M0E _51 Engine / Hybrid System _018287 1NZ-FE EMISSION CONTROL _0090366 EMISSION CONTROL SYSTEM CO CONTROL F

1NZ-FE EMISSION CONTROL  EMISSION CONTROL SYSTEM  CONTROL  EXHAUST EMISSION CONTROL  


FUNCTION OF MAIN COMPONENTS


a.

The main components of the exhaust emission control system are as follows:

Component Function

*1: Models with EURO 5 emission regulations

*2: Models with EURO 4 emission regulations

TWC The TWCs reduce emissions by oxidation of CO and HC in exhaust gas and reduction of NOx.
Oxygen Sensor This sensor detects the oxygen concentration in the exhaust emission by measuring the electromotive force which is generated in the sensor itself.
Air Fuel Ratio Sensor*1 Is used to determine the concentration of oxygen remaining in the exhaust gas, and has a characteristic where its output is proportional to the air fuel ratio.
ECM
·

Optimizes the air fuel ratio according to signals from the oxygen sensor.*2

·

Controls the volume of fuel consumed based primarily on the signal from the air fuel ratio sensor, with minor corrections based on the signal from the oxygen sensor. This control optimizes the air fuel ratio.*1