Home › Engine / Hybrid System › 2NZ-FE EMISSION CONTROL › EMISSION CONTROL SYSTEM › 2013.08–2016.10
NM30M0E _51 Engine / Hybrid System _018296 2NZ-FE EMISSION CONTROL _0090367 EMISSION CONTROL SYSTEM CO CONTROL F

2NZ-FE EMISSION CONTROL  EMISSION CONTROL SYSTEM  CONTROL  BLOWBY GAS VENTILATION CONTROL  


FUNCTION OF MAIN COMPONENTS


a.

The main components of the blowby gas ventilation system are as follows:

Component Function
Ventilation Valve Sub-assembly Opens and closes the valve using vacuum generated in the intake manifold and controls the flow rate of the blowby gas.



SYSTEM CONTROL


a.

By introducing blowby gas that has a large amount of HC into the air intake side and burning it again, the system attempts to enhance the emission performance. Returning blowby gas volume is regulated to the appropriate amount corresponding to the engine operating conditions, reducing the engine oil quantity taken away and engine idling speeds.


b.

The ventilation valve sub-assembly passage returns the blowby gas into the area after the throttle valve in accordance with the intake manifold vacuum.


c.

When load is low, the passage from the cylinder head cover sub-assembly to the area before the throttle valve increases the air purification performance inside the crankcase by introducing fresh air, and when load is high, the passage circulates the blowby gas together with the ventilation valve sub-assembly side passage due to the intake manifold vacuum.

W105000C01
1.938,1.188 1.698,0.604 1.698,0.604 1.583,0.604 true 1.365,0.521 1.615,0.729 0.25,0.208 10 false *1 2.25,0.563 2.5,0.771 0.25,0.208 10 false *a 4.802,0.542 5.052,0.75 0.25,0.208 10 false *b
*1 Ventilation Valve Sub-assembly - -
*a When load is low *b When load is high
V100135

Blowby Gas
V100136

Fresh Air