Home › Engine / Hybrid System › 1NZ-FE STARTING › STARTING SYSTEM › 2013.08–2016.10
NM30M0E _51 Engine / Hybrid System _018291 1NZ-FE STARTING _0090376 STARTING SYSTEM GE GENERAL F

1NZ-FE STARTING  STARTING SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

A P (conventional planetary reduction) type starter assembly is used.


b.

A cranking hold function is used on models with the smart entry and start system. Once the engine switch is pushed, this function operates the starter until the engine starts.

W111952C01
3.688,3.323 4,3.521 0.313,0.198 10 false *a
*a Length - -




SPECIFICATION


Starter Type P Type (Conventional Type)
Length 153.6 mm (6.05 in.)
Weight 2800 g (6.2 lb)
Rating Voltage 12 V
Rating Output 0.8 kW
Rotating Direction (Viewed from Pinion Side) Clockwise


PRECAUTION


a.

Cranking hold function has following safety features:

i.

While the engine is running normally, the starter does not operate.


ii.

Even if the driver keeps pressing the engine switch, the certification ECU (smart key ECU assembly) stops the output of the STAR and ACCD signals when the engine speed becomes higher than 1200 rpm. Thus, the starter operation stops and the certification ECU (smart key ECU assembly) energizes the ACC relay.


iii.

In case the driver keeps pressing the engine switch and the engine does not start, the certification ECU (smart key ECU assembly) stops the output of the STAR and ACCD signals after 30 seconds have elapsed. Thus, the starter operation stops and the certification ECU (smart key ECU assembly) energizes the ACC relay.


iv.

Also, if the certification ECU (smart key ECU assembly) can not detect a continuous engine speed signal although the starter is operating and this continues for 6 seconds, the certification ECU (smart key ECU assembly) will stop sending out STAR and ACCD signals. As a result, the starter will stop operating and then the certification ECU (smart key ECU assembly) will energize the ACC relay.