CONSTRUCTION
Planetary Gear Unit
A CR-CR type planetary gear is used in the planetary gear unit, which is located on the input shaft. In this planetary gear unit, the front planetary carrier is joined to the rear ring gear, and the rear planetary carrier is joined to the front ring gear. As a result, the unit has been made significantly simpler and compact.
A centrifugal fluid pressure canceling mechanism is used in the C1 clutch, which is applied when downshifting from 4th.
| *1 | Counter Drive Gear | *2 | Input Shaft |
| *3 | Rear Planetary Gear Assembly | *4 | Front Planetary Gear Assembly |
| *5 | Counter Driven Gear | - | - |
The functions of the clutches and brakes are as follows:
| Component | Function | |
|---|---|---|
| C1 | Forward Clutch | Connects the input shaft and front planetary sun gear. |
| C2 | Direct Clutch | Connects the intermediate shaft and rear planetary carrier. |
| C3 | Reverse Clutch | Connects the intermediate shaft and rear planetary sun gear. |
| B1 | OD and 2nd Brake | Locks the rear planetary sun gear. |
| B2 | 2nd Brake | Prevents the rear planetary sun gear from turning counterclockwise. |
| B3 | 1st and Reverse Brake | Locks the front planetary ring gear and rear planetary carrier. |
| F1 | No. 1 1-way Clutch | Prevents the rear planetary sun gear from turning counterclockwise. |
| F2 | No. 2 1-way Clutch | Prevents the front planetary ring gear and rear planetary carrier from turning counterclockwise. |
| Planetary Gears | These gears change the route through which driving force is transmitted, in accordance with the operation of both clutch and brake, in order to increase or reduce the output speed. | |
OPERATION
Transmission Power Flow
○: Operation
- : Not operation