CONSTRUCTION
Planetary Gear Unit
A ravigneaux type planetary gear is used in the planetary gear unit which is located on the input shaft. This planetary gear combines a set of sun gears with 2 different diameters and a short pinion gear and a long pinion gear.
A centrifugal fluid pressure canceling mechanism is used in the C1 clutch, which is applied when downshifting from 4th.
| *1 | Counter Drive Gear | *2 | Input Shaft Assembly |
| *3 | Planetary Gear Assembly | *4 | Long Pinion Gear (Planetary Gear Assembly) |
| *5 | Short Pinion Gear (Planetary Gear Assembly) | *6 | Planetary Ring Gear |
| *7 | Planetary Sun Gear Sub-assembly | *8 | Rear Planetary Sun Gear Assembly |
| *9 | Counter Driven Gear | - | - |
The functions of the clutches and brakes are as follows:
| Component | Function | |
|---|---|---|
| C1 | Forward Clutch | Connects the input shaft assembly and planetary sun gear sub-assembly. |
| C2 | Direct Clutch | Connects the input shaft assembly and planetary carrier. |
| C3 | Reverse Clutch | Connects the input shaft assembly and rear planetary sun gear sub-assembly. |
| B1 | OD and 2nd Brake | Locks the rear planetary sun gear. |
| B2 | 2nd Brake | Prevents the rear planetary sun gear from turning counterclockwise. |
| B3 | 1st and Reverse Brake | Locks the planetary carrier. |
| F1 | No. 1 1-way Clutch | Prevents the rear planetary sun gear from turning counterclockwise. |
| F2 | No. 2 1-way Clutch | Prevents the planetary carrier from turning counterclockwise. |
| Planetary Gears | These gears change the route through which driving force is transmitted, in accordance with the operation of both clutch and brake, in order to increase or reduce the output speed. | |
OPERATION
Transmission Power Flow
○: Operation
- : Not operation