CONSTRUCTION
To optimize the toe and camber change during tramping, the cross section of the axle beam has been changed to an opposite V-shape.
A compact, highly rigid and hollow type trailing arm is used. The trailing arm is obliquely fitted to the vehicle body via a trailing arm bush.
A highly rigid, solid type rear stabilizer bar is used.
| *1 | Trailing Arm (Rear Axle Beam Assembly) | *2 | Axle Beam (Rear Axle Beam Assembly) |
| *3 | Rear Stabilizer Bar | - | - |
| *a | Cross Section of Trailing Arm Bush (Rear Axle Carrier Bush) | *b | A-A Cross Section |
|
Front | - | - |