CONSTRUCTION
The widths of the grooves of the pulleys are changed through hydraulic control.
During acceleration, the operation of the linear solenoid valve SLP increases the oil pressure of the primary pulley, thus decreasing the width of the pulley groove.
During deceleration, the operation of the linear solenoid valve SLP decreases the oil pressure of the primary pulley, thus increasing the width of the pulley groove.
The secondary pulley is hydraulically controlled by the linear solenoid valve SLS. The linear solenoid valve SLS controls the belt clamping pressure to ensure the proper power transmission efficiency.
| *1 | Primary Pulley | *2 | Steel Belt |
| *3 | Secondary Pulley | - | - |
| *a | Pulley Ratio (Low) | *b | Pulley Ratio (High) |
| *c | Groove Width (Large) | *d | Groove Width (Small) |
The primary pulley uses a single piston construction.
| *a | Pulley Ratio (Low) | *b | Pulley Ratio (High) |
| *c | Chamber | - | - |
|
Oil Pressure | - | - |
The steel belt consists of elements and 2 rows of steel rings. In contrast to chains and V-belts which transmit power through the use of tensile force, this steel belt uses the compressive action (pushing force) of the elements to transmit power.
| *1 | Steel Ring | *2 | Element |
OPERATION
The changing of the pulley ratio is accomplished in a continuously variable manner by varying the widths of the grooves of the primary and secondary pulleys.
| *1 | Primary Pulley | *2 | Secondary Pulley |
| *3 | Steel Belt | *4 | Planetary Gear |
| *5 | Reduction Driven Gear | *6 | Reduction Drive Gear |
| *7 | Reverse Brake | *8 | Forward Clutch |
| *9 | Input Shaft | *10 | Differential Ring Gear |
| *11 | Differential Drive Pinion | - | - |
| *1 | Primary Pulley | *2 | Secondary Pulley |
| *3 | Steel Belt | *4 | Planetary Gear |
| *5 | Reduction Driven Gear | *6 | Reduction Drive Gear |
| *7 | Reverse Brake | *8 | Forward Clutch (ON) |
| *9 | Input Shaft | - | - |
| *a | Groove Width (Large) | *b | Groove Width (Small) |
| *1 | Primary Pulley | *2 | Secondary Pulley |
| *3 | Steel Belt | *4 | Planetary Gear |
| *5 | Reduction Driven Gear | *6 | Reduction Drive Gear |
| *7 | Reverse Brake | *8 | Forward Clutch (ON) |
| *9 | Input Shaft | - | - |
| *a | Groove Width (Small) | *b | Groove Width (Large) |
| *1 | Primary Pulley | *2 | Secondary Pulley |
| *3 | Steel Belt | *4 | Planetary Gear |
| *5 | Reduction Driven Gear | *6 | Reduction Drive Gear |
| *7 | Reverse Brake | *8 | Forward Clutch |
| *9 | Input Shaft | - | - |
| *a | Groove Width (Large) | *b | Groove Width (Small) |
| *1 | Primary Pulley | *2 | Secondary Pulley |
| *3 | Steel Belt | *4 | Planetary Gear |
| *5 | Reduction Driven Gear | *6 | Reduction Drive Gear |
| *7 | Reverse Brake (ON) | *8 | Forward Clutch |
| *9 | Input Shaft | - | - |
| *a | Groove Width (Large) | *b | Groove Width (Small) |