CONSTRUCTION
The brake actuator assembly consists of the actuator portion and skid control ECU.
The actuator portion regulates the hydraulic brake pressure to each wheel cylinder.
| *1 | Skid Control ECU | *2 | Actuator Portion |
| *1 | Skid Control ECU | *2 | Actuator Portion |
The brake actuator assembly is constructed with the following hydraulic circuit:
| *1 | Brake Actuator Assembly | *2 | Pressure Holding Solenoid Valve |
| *3 | Pressure Reduction Solenoid Valve | *4 | Pump |
| *5 | Reservoir | *6 | Front Wheel Cylinder RH |
| *7 | Rear Wheel Cylinder LH | *8 | Rear Wheel Cylinder RH |
| *9 | Front Wheel Cylinder LH | - | - |
| *a | From Master Cylinder | - | - |
| *1 | Brake Actuator Assembly | *2 | Master Cylinder Pressure Sensor |
| *3 | Master Cylinder Cut Solenoid Valve | *4 | Pressure Holding Solenoid Valve |
| *5 | Pressure Reduction Solenoid Valve | *6 | Pump |
| *7 | Reservoir | *8 | Front Wheel Cylinder RH |
| *9 | Rear Wheel Cylinder LH | *10 | Rear Wheel Cylinder RH |
| *11 | Front Wheel Cylinder LH | - | - |
| *a | From Master Cylinder | - | - |