CONSTRUCTION
A single valve type electronic control throttle body with motor assembly that drives the throttle valve by a motor is adopted to ensure excellent driving stability.
A DC motor with good response and low power consumption is adopted for the motor for throttle valve drive.
Driver operations (the amount of the accelerator pedal being depressed) are transmitted to the ECM by the accelerator pedal sensor provided on the accelerator pedal. The ECM determines the throttle valve opening angle that matches the driving status to drive the throttle motor. The throttle valve opening angle is fed back to the ECM by the throttle position sensor.
When an error is detected, the driver is notified by a warning light in the combination meter assembly and current to the motor is cut. This causes the throttle valve to return to its predetermined angle by the throttle valve return spring. Fuel cut and ignition retard adjust the engine output according to the accelerator pedal opening angle to allow the vehicle to continue at a minimal speed.
| *1 | Throttle Control Motor | *2 | Throttle Valve |
| *3 | Return Spring | - | - |
| *a | Throttle Position Sensor Potion | - | - |
| M- | Motor Terminal (Input When Throttle Valve is "Open" [Output to M+]) |
| M+ | Motor Terminal (Input When Throttle Valve is "Closed" [Output to M-]) |
| E2 | Ground Terminal |
| VTA2 | Sensor Output Terminal |
| VC | Power Terminal |
| VTA1 | Sensor Output Terminal |