CONSTRUCTION
The oil pan sub-assembly is made of aluminum die-cast.
The number of components has been reduced through the integration of the oil strainer and the oil pan sub-assembly, achieving a weight reduction.
The profile of the inlet opening of the oil strainer has been redesigned to let sufficient amount of oil to enter, so that further reliability is achieved.
The capability of the No. 1 oil pan baffle plate in removing air bubbles from the oil has been improved by reshaping the edge profile to a curved one, and re-positioning the oil drain passages.
The No. 2 oil pan baffle plate prevents oil mist in the crankcase from entering the blowby gas passages, enhancing reliability.
| *1 | No. 1 Oil Pan Baffle Plate | *2 | No. 2 Oil Pan Baffle Plate |
| *3 | Oil Pan Sub-assembly | - | - |
| *a | Oil Drain Passage | *b | Oil Strainer |
| *c | Inlet Opening | - | - |
|
Oil | - | - |